Zanussi ZDI 600 QX Instrukcja Użytkownika

User manualDishwasherZDI 600 QX

• Ensure that the electrical and water connec-tions comply with the installation instructions• Remove all packaging from inside the appli-ance• Set th

The water softener must be set in both ways:manually, using the water hardness dial andelectronically.Setting the water softener manually (see table)S

Remove any trace of salt. Replace the cap tightlyturning it clockwise until itstops with a click.IMPORTANT!Immediately start a complete programme.IMPO

Adjusting the dosage of rinse aidIncrease the dose if there are drops of water orlime spots on the dishes after washing.Reduce the dose if there are w

For washing in the dishwasher the following cutlery and dishesare not suitable: are of limited suitability:• Cutlery with wooden, horn, china or mothe

Load the lower basket. Ar-range serving dishes andlarge lids around the edgeof the basket.The two rows of prongs onthe lower basket can beeasily lower

To move to the higher position proceed as follows:1. Pull out the basket until it stops.2. Carefully lift both sides upwards until the mecha-nism is e

For programmes with pre-wash add an additionaldetergent dose in com-partmentB.When using detergenttablets: place detergenttablets in compartment A.Clo

If the drying results are not satisfactory wesuggest that you:1. Fill up the rinse aid dispenser with rinse aid.2. Activate the rinse aid dispenser.3.

Clean filters A, B and Cthoroughly under runningwater.Turn the handle about 1/4turn anticlockwise and re-move filters B and C.Remove filter A from the

Thank you for selecting ourapplianceWe wish you lots of enjoyment with your newappliance and we hope that you will considerour brand again when purcha

2. Leave the door ajar to prevent the forma-tion of any unpleasant smells.3. Leave the inside of the machine clean.Frost precautionsAvoid placing the

What to do if…The dishwasher will not start or stops duringoperation. Certain problems are due to the lackof simple maintenance or oversights, which c

Once these checks have been carried out;close the dishwasher’s door and switch on theappliance. Press the button of the programmethat was running befo

Technical dataDimensions Width x Height x Depth (cm) 59,6 x 81,8-89,8 x 57,5Electrical connectionVoltage - Overall power - FuseInformation on the elec

Hints for test institutesTesting in accordance with EN 60704 must becarried out with appliance fully loaded and us-ing the test programme (see "

This dishwasher is designed to be fitted undera kitchen counter or work surface.No further openings for the venting of thedishwasher are required, but

Drain hoseConnect drain hose to thesink.Required height: 30 to 100cm above bottom of thedishwasher.Ensure that the hoses arenot kinked, crushed or en-

27

www.electrolux.comwww.zanussi-electrolux.co.uk117972120-012008

Safety informationIn the interest of your safety and to ensure thecorrect use, before installing and first using theappliance, read this user manual

Installation• Check your dishwasher for any transportdamage. Never connect a damaged ma-chine. If your dishwasher is damaged con-tact your supplier.•

IMPORTANT!A sequence of displayed and audible signals will guideyou in the setting up of the appliance, the selection ofwashing programmes and options

Option menu Option submenuECO DRYAllows you to shorten the drying phase to only 15 minutes. It is not available withall washing programmes (see "

gramme: prewash - main wash - rinses -drying.2. In this row several details are displayed:–Setting mode guide to the selection ofthe washing programme

Cancel a delay start or awashing programme inprogress1. Press simultaneously both Option and De-lay start buttons.2. The message CONFIRM CANCEL ? isdi

Programme Degree of soil Type of load Programme description55° QuickNormal soil Crockery and cutlery Main wash1 intermediate rinseFinal rinse70° Inten