Zanussi ZDF311S Instrukcja Użytkownika

User manualDishwasherZDF 311

Water hardness Adjusting the water hardnesssettingUse of salt°dH °TH mmol/l manually electronically51 - 70 91 - 125 9,1 - 12,5 2 level 10 yes43 - 50 7

• The dishwasher must be switched off.Switch on the dishwasher by pressing the On/Offbutton.•Press and hold simultaneously function buttons Band C un

Remove any trace of salt. Replace the cap tightlyturning it clockwise until itstops with a click.IMPORTANT!Immediately start a complete programme.IMPO

Adjusting the dosage of rinse aidIncrease the dose if there are drops of water orlime spots on the dishes after washing.Reduce the dose if there are w

For washing in the dishwasher the following cutlery and dishesare not suitable: are of limited suitability:• Cutlery with wooden, horn, china or mothe

The two rows of prongson the lower basket canbe easily lowered to allowyou to load pots, pansand bowls. Load upper basket. Lightitems (plastic bowls

To move to the higher position proceed as fol-lows:1. Pull out the basket until it stops.2. Carefully lift both sides upwards until the mecha-nism is

For programmes withprewash add an addition-al detergent dose in com-partmentB.When using detergenttablets: place detergenttablets in compartmentA.Clos

function "indicator light illuminates. This meansthat the function is active.To deactivate the function press the same but-tons again until the i

Care and cleaningCleaning the filtersIMPORTANT!NEVER use the dishwasher without filters. In-correct repositioning and fitting of the filters willprodu

Thank you for selecting ourapplianceWe wish you lots of enjoyment with your newappliance and we hope that you will considerour brand again when purcha

abrasive products, scouring pads or solvent(acetone, trichloroethylene etc...).Internal cleaningEnsure that the seals around the door, the de-tergent

caused by inappropriate waste handling of thisproduct. For more detailed information aboutrecycling of this product, please contact yourlocal council,

Fault code and malfunction Possible cause and solution•The programme does not start.• The dishwasher door has not been properly closed.Close the door.

The wash results are not satisfactoryThe dishes are wet and dull • Rinse aid was not used.• The rinse aid dispenser is empty.There are streaks, milky

Consumption valuesProgramme Programme duration(in minutes)Energy consumption(in kWh)Water (litres)Eat-Load-Run30 0,9 9BIO 50° (Test pro-gramme for Tes

cup racks: position AInstallation WARNING!Any electrical and/or plumbing work required toinstall this appliance should be carried out by aqualified e

Drain hoseConnect drain hose tothe sink. Secure it withthe supplied hose clamp.Required height: 30 to100 cm above bottom ofthe dishwasher.Ensure that

Fitting under a counterBy removing the dishwasher s worktop, youcan install it under a close fitting sink unit or apre-existing top.Be sure that once

livered to the first end user. These guar-antee terms do not apply in the event ofuse for professional or equivalent purpo-ses.2. Performing the guara

15. Except in the event where liability is legallyimposed, this declaration of guaranteeterms excludes any compensation fordamage outside the applianc

Safety informationIn the interest of your safety and to ensure thecorrect use, before installing and first using theappliance, read this user manual c

• The appliance guarantee is for the same pe-riod and to the same extent for labour andparts as exists in your new country of resi-dence for this part

Lietuva +370 5 2780609 Ozo 10A, LT 08200 VilniusLuxembourg +352 42 431 301 Rue de Bitbourg, 7, L-1273 HammMagyarország +36 1 252 1773 H-1142 Budapest

www.electrolux.com156995211-00-14092007Subject to change without notice

Installation• Check your dishwasher for any transportdamage. Never connect a damaged ma-chine. If your dishwasher is damaged con-tact your supplier.•

Control panel1On/Off button2 Programme selection buttons3Delay start button4 Indicator lights5Function buttonsSetting modeIMPORTANT!Always remember th

Function buttonsIn addition to the dishwashing programme selection,the following functions can also be set with the helpof these buttons.– the setting

Delay start buttonThis option allows the start of the programme to bedelayed by 3 or 6 hours. Before selecting the washingprogramme, press the On/Off

Indicator lightsRinse aid2)Illuminates when rinse aid needs to be filled.1) As soon as you select a washing programme, the phase indicator lights for

Programme Degree of soil Type of load Programme descrip-tionRinse and Hold Any.Partial load (to be completed later in the day).1 cold rinse (to avoidf