Zanussi PTDF64 Instrukcja Użytkownika Pobierz pdf

Commissioning

When the hob has been fully installed it will be

necessary to check the minimum flame setting. To do

this, follow the procedure below.

- Turn the gas tap to the MAX position and ignite.

- Set the gas tap to the MIN flame position then turn

the control knob from MIN to MAX several times.

If the flame is unstable or is extinguished follow the

procedure below.

Procedure:

Re-ignite the burner and set to MIN.

Remove the control knob, insert a thin

bladed screwdriver down the hole in the

front panel and turn the adjustment screw

until the flame is steady and does not

extinguish, when the knob is turned from

MIN to MAX. Repeat this procedure for all

burners.

Technical Maintenance

Check at regular intervals the condition and

serviceability of the gas connection hose and pressure

regulator, if any is fitted; in case of malfunction, do

not repair but replace the whole faulty part.

To ensure a smooth and safe operation, it is necessary

to periodically grease the gas taps.

1 2 3 4 5 6 ... 12 13

Podsumowanie treści

Strona 1 - Technical Maintenance

14CommissioningWhen the hob has been fully installed it will benecessary to check the minimum flame setting. To dothis, follow the procedure below.- T

Strona 2 - Electrical connections

51. Hob Top2. Auxiliary Burner3. Semi-rapid Burners4. Powered Rapid Burner5. Control knob for front left burner (auxiliary)6. Control knob for back le

Strona 3

4For the UserDescriptionof the Hob Page 5Operation Page 6Maintenanceand Cleaning Page 7SomethingNot Working Page 8ContentsFor the InstallerTec

Strona 4 - Building In

3Important Safety InformationYou MUST read these warnings carefully before installing or using theappliance.Installationl This appliance

Strona 5 - Installation

2GAS HOBMODELSPW 64PN 64PX 64PTDF 64INSTRUCTION BOOKLET

Strona 6 - Engineer technical data

13Electrical connectionsAny electrical work required to install thisappliance should be carried out by aqualified electrician or competent person,in

Strona 7 - Something Not Working?

12FO 0199aCarry out the building in of the hob as follows: put the seals supplied with the hob, on theedges of the cut out, as shown in the diagram,t

Strona 8 - Maintenance and Cleaning

11Building InBuilding over a cupboard or drawerIf the hob is to be installed above a cupboard ordrawer it will be necessary to fit a heat resist

Strona 9 - Operation

10Rectangular cut-out size for hob560150 min48055 min.FO 2038Dimensions are given in mm.InstallationCut Out SizeThe dimensions of the cut-out ar

Strona 10

9OVERALL DIMENSIONSWidth: 580 mm.Depth: 510 mm.Height: 84 mm.Weight: 11 Kg.CUT OUT DIMENSIONSWidth: 560 mm.Depth: 480 mm.Thickness: 30 mm.Instructi

Strona 11 - For the Installer

8Something Not Working?If the appliance is not working correctly, please carry out the following checks before contacting your localService Centre.

Strona 12

7FO 2237FO 2032Before any maintenance or cleaning can becarried out, you must DISCONNECT thehob from the electricity supply.The hob is best cleaned wh

Strona 13 - INSTRUCTION BOOKLET

6OperationTo light a burner, turn the relevant control knobanticlockwise to maximum position and push it downto ignite. Keep the control knob pressed