Zanussi ZGS799ITX Instrukcja Użytkownika Pobierz pdf (Strona 18)

Electrical Connection

Any electrical work required to install

this appliance should be carried out

by a qualified electrician or

competent person, in accordance

with the current regulations.

THIS APPLIANCE MUST BE

EARTHED.

The manufacturer declines any liability should

these safety measures not be observed.

This appliance is designed to be connected to

a 230 V 50 Hz AC electrical supply.

Before the appliance is connected:

1) check that the main fuse and the domestic

installation can support the load (see the

rating label);

2) check that the power supply is properly

earthed in compliance with the current rules;

3) check the socket or the double pole switch

used for the electrical connection can be

easily reached with the appliance built in the

forniture unit. Before switching on, make sure

the electricity supply voltage is the same as

that indicated on the appliance rating plate.

The rating plate is located on the bottom of

the hob. A copy is attached on the back cover

of this book.

The appliance is supplied with a 3 core flexible

supply cord incorporating a plug. Connect the plug

to an adequate socket.

Permanent Connection

In the case of a permanent connection, it is

necessary that you install a double pole switch

between the appliance and the electricity supply

(mains), with a minimum gap of 3 mm between the

switch contacts and of a type suitable for the

required load in compliance with the current electric

regulations.

The switch must not break the yellow and green

earth cable at any point and it should be 2-3 cm

longer than the other cables.

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

Replacement of the connection cable

The connection of the voltage cable to the

appliance's terminal block is of type "Y". This

means that its replacement requires the

specific equipment of a technician. In this case,

only cable type H05V2V2-F T90 must be used.

The cable section must be suitable to the vol-

tage and the working temperature. The yellow/

green earth wire must be approximately 2 cm.

longer than the phase wires (Fig. 7-a).

To open the terminal block and reach the

terminals, proceed as follows:

" insert the point of a screwdriver into the

visible protrunding part of the terminal block;

" exert a light pressure and lift (Fig. 7-b)

Earth

(yellow/green)

Neutral

Fig. 7

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Zanussi ZGS799ITX Instrukcja Użytkownika Strona 18

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Zanussi ZGS799ITX