Zanussi ZDF17002XA Instrukcja Użytkownika

GETTING STARTED?EASY.User ManualZDF17002XAEN User ManualDishwasher

ADDING RINSE AIDAThe rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hotrinse phase.• Fill the d

• Adjust the water softener to the lowest level.• Set the rinse aid dispenser to the lowest position.STARTING A PROGRAMME1. Keep the appliance door aj

tablets (e.g. ''3in1'', ''4in1'', ''All in 1''). Follow theinstructions written on the pac

CLEANING THE FILTERSBAC• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C

INTERNAL CLEANING• Carefully clean the appliance, including therubber gasket of the door, with a soft dampcloth.• To maintain the performance of your

Problem and alarm code Possible cause and solutionThe programme lasts too long. • If the delay start option is set, cancel the delay setting or waitfo

Problem Possible cause and solutionPoor drying results. • Tableware has been left for too long inside a closed appli-ance.• There is no rinse aid or t

Problem Possible cause and solutionLimescale deposits on the table-ware, on the tub and on the in-side of the door.• The level of salt is low, check t

RATING PLATEMod. ... ... ...Prod. No. ... ... ... Ser. No. ...INFORMATION FOR TEST INSTITUTESFor all the necessary information for testperfor

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP117873491-A-122018

• If the supply cord is damaged, it must be replaced by themanufacturer, its Authorised Service Centre or similarlyqualified persons in order to avoid

Authorised Service Centre to replace the waterinlet hose.USE• Do not sit or stand on the open door.• Dishwasher detergents are dangerous. Obeythe safe

INDICATORSIndicator DescriptionSalt indicator. It is on when the salt container needs refilling. It is always off whilethe programme operates.Rinse ai

ProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Water(l)Energy(kWh)Duration(min) 6)• Normal orlight soil• Delicatecrockery andg

1. Press and hold Delay and XtraDry until theindicators , , and flash and the display is blank.As the appliance stores the saved settings, there i

• The indicator still flashes.• The display shows the current setting: e.g.= level 4.– The levels of rinse aid range from 0A to6A.– Level 0A means n

XTRADRYActivate this option to boost the dryingperformance.XtraDry is a permanent option for all programmesother than . It is automatically activated