Zanussi ZDTS300 Instrukcja Użytkownika

User manualDishwasherZDTS 300

Water hardness Adjusting the water hardnesssettingUse of salt°dH °TH mmol/l manually electronically51 - 70 91 - 125 9,1 - 12,5 2 level 10 yes43 - 50 7

1. Press the On/Off button. The dishwashermust be in setting mode.2. Simultaneously press and hold functionbuttons B and C until the lights of the fun

Unscrew the cap.Only before filling withsalt for the first time, fillthe salt container with wa-ter.Using the funnel provided,pour in the salt until t

Use of rinse aidOpen the lid.Fill up with rinse aid. Themaximum level for filling isindicated by "max"Clean up any rinse aidwhich overflows.

• Before loading the dishes, you should:– Remove all left over food and debris.– Soften remnants of burnt food in pans• When loading the dishes and cu

Load cutlery. For best re-sults we recommend youto use the cutlery grid pro-vided (if the size and di-mensions of the cutleryallow it)Place knives and

To move to the higher position proceed as follows:1. Pull out the basket until it stops.2. Carefully lift both sides upwards until the mecha-nism is e

For programmes with pre-wash add an additionaldetergent dose in com-partmentB.When using detergenttablets: place detergenttablets in compartment A.Clo

Clean filters A, B and Cthoroughly under runningwater.Turn the handle about 1/4turn anticlockwise and re-move filters B and C.Remove filter A from the

2. Leave the door ajar to prevent the forma-tion of any unpleasant smells.3. Leave the inside of the machine clean.Frost precautionsAvoid placing the

Thank you for selecting ourapplianceWe wish you lots of enjoyment with your newappliance and we hope that you will considerour brand again when purcha

What to do if ...The dishwasher will not start or stops duringoperation.Certain problems are due to the lack of simplemaintenance or oversights, which

Once these checks have been carried out;switch on the dishwasher. The programme willcontinue from the point at which it was inter-rupted.If the malfun

Technical dataDimensions Width x Height x Depth (cm) 44,6 x 81,8-89,8 x 55,5Electrical connectionVoltage - Overall power - FuseInformation on the elec

rinse aid respectively and using the test pro-gramme (see "Consumption values").Full load: 9 standard place settingsAmount of detergent requ

WARNING!The dishwasher must be secured against tilting.Therefore make sure that the counter it is fixedunder, is suitably secured to a fixed structu

CAUTION!A water inlet hose with safety valve MUST onlybe replaced by your local Service Force Centre.Drain hoseConnect drain hose to thesink.Require

on the rating plate match that of the supplywhere the appliance is to be installed.The fuse rating is also to be found on the ratingplate.Always plug

27

www.electrolux.com117977680-00-31102007Subject to change without notice

Safety informationIn the interest of your safety and to ensure thecorrect use, before installing and first using theappliance, read this user manual c

Installation• Check your dishwasher for any transportdamage. Never connect a damaged ma-chine. If your dishwasher is damaged con-tact your supplier.•

1On/Off button2Programme selection buttons3Delay start button4 Indicator lights5Function buttonsFunctions buttonsIn addition to the dishwashing progra

Audible signalsAudible signals have been introduced to helpindicate which operations the dishwasher isperforming:• setting the water softener,• end of

4. Press the button corresponding to the re-quired programme (see "Washing pro-grammes" chart).When a programme has been selected thecorresp

IMPORTANT!When the washing programme has finished, itis recommended that the dishwasher is un-plugged and the water tap turned off.Washing programmesP

First useBefore using your dishwasher for the first time:• Ensure that the electrical and water connec-tions comply with the installation instructions