Zanussi ZCG62396XA Instrukcja Użytkownika Pobierz pdf (Strona 25)

Changing from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts are

back into their initial position.

There is a risk of injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob for the hob to the minimum

position.

6. Remove the knob for the hob again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob for the hob back on.

Oven injector replacement

1. Remove the bottom plate of the oven cavity

to get access to the oven burner .

2. Carefully remove from the burner the

thermocouple A. Next remove the spark

plug B.

A

B

3.

Unscrew the screw and slowly pull out the

burner.

1

2

4. Release the burner injector with a 7 mm

socket spanner and replace it with a right

one.

Assemble the burner in a revers sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the new gas

type.

Adjusting the minimum gas level on the

oven burner

1. Disconnect the appliance from the

electricity.

www.zanussi.com 25

1 2 ... 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag