Zanussi ZCG62496XA Instrukcja Użytkownika Pobierz pdf (Strona 24)

If the appliance is set for liquid gas

you can change it to natural gas, with

the correct injectors.

The gas rate is adjusted to suit.

WARNING! Before you replace the

injectors, make sure that the gas

knobs are in the Off position.

Disconnect the appliance from the

electrical supply. Let the appliance

cool down. There is a risk of injury.

The appliance is set to default gas. To

change the setting choose a pipe

holder from the list. Always use the

gasket sealing.

A CB

A. Gas connection end

B. Natural Gas pipe holder

C. LPG pipe holder

HOB INJECTORS REPLACEMENT

Replace the injectors when you change the gas

type.

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. Remove the injectors with a socket spanner 7.

4. Replace injectors with the ones necessary for

the type of gas you use.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type of

gas supply.

You can find this plate in the bag

supplied with the appliance.

If the supply gas pressure is not constant or it is

different from the necessary pressure, install an

applicable pressure adjuster on the gas supply

pipe.

ADJUSTING THE MINIMUM GAS LEVEL ON

THE HOB BURNER

1. Disconnect the appliance from the electricity.

2. Remove the knob for the hob. If there is no

access to the bypass screw dismount the

control panel before adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A

A

Changing from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

24

1 2 ... 19 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag