Zanussi Z714W43BI Instrukcja Użytkownika

GETTING STARTED?EASY.User ManualZ714W43BIEN User ManualWashing Machine

553 mm596 mm140 mm76 mm50 mm50 mm819 mmIf hoses run behind the appliance, makesure that nothing closes the small re-cess indicated with the measures 5

1. Remove the screws of the top cover on the rear ofthe appliance and install the anti-tilting device asshown in the drawing.~10mm2. Adjust the anti-t

Reversibility of the cupboard doorCarry out the cupboard door reversibility before theappliance is built in completely.MNOIf the cupboard door has to

16-22 mm22±1,5 mm449mm595-598 mmØ 35 mm12,5 - 14 mmSet the position of the lower hole respecting dimen-sions and distances shown in the drawing (449mm

2N1EDCCounter-magnetThe appliance is pre set for a magnetic closure.For a correct closure:1. Position the screw C and the counter-magnet Don the magne

CONTROL PANELCONTROL PANEL DESCRIPTION12349 657810The permanent options are set byholding pressed the relative button for3 seconds at least.1Programme

DISPLAYA B CADoor locked indicator.BChild safety lock indicator.CThe digital indicator can show:• Programme duration (e. g. ).• Delay time (e. g. ).

• To activate/deactivate this option , hold downthe Prewash button until relevant indicator comes on/goes off.SPIN When you set a programme, the app

PROGRAMMESPROGRAMME CHARTProgrammeDefault tempera-tureTemperaturerangeReferencespin speedSpin speedrange(rpm)MaximumloadProgramme description(Type of

ProgrammeDefault tempera-tureTemperaturerangeReferencespin speedSpin speedrange(rpm)MaximumloadProgramme description(Type of load and soil level)Machi

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

ProgrammeDefault tempera-tureTemperaturerangeReferencespin speedSpin speedrange(rpm)MaximumloadProgramme description(Type of load and soil level)Wool/

ProgrammeSpinPrewashDelay StartFlextimeSpin/Drain Rinse Machine Clean Duvet Daily Wash

Programmes Load (kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approximateprogrammeduration(minutes)Remainingmoisture(%)1)Cottons40°C7 1.00 80

BEFORE FIRST USE1. Make sure that the electrical power is availableand the water tap is open.2. Pour 2 litres of water into the detergentcompartment m

CHECK THE POSITION OF THE DETERGENTFLAP1. Pull out the detergent dispenser until it stops.2. Press the lever down to remove the dispenser.3. To use po

3. Touch the Start/Pause button again tostart the new countdown.THE AUTOADJUST SYSTEM LOADDETECTIONAfter touching the Start/Pause button:1. The Au

• The door stays locked.• You must drain the water to open the door:1. If necessary, touch the Spin button to decreasethe spin speed proposed by the a

for all types of fabric, or special ones forwoollens only.• Do not mix different types of detergents.• To help the environment, do not use more thanth

CLEANING THE DRUMRegularly examine the drum to prevent unwanteddeposits.Rust deposits in the drum may occur due to rustingforeign body in the washing

• The drum does not turn.• The appliance makes an unusual noise becauseof the blockage of the drain pump.• The display shows the alarm code .WARNING!

– areas for communal use in blocks of flats or in launderettes.• Do not exceed the maximum load of 7 kg (refer to the"Programme chart" chapt

126. Turn the filter anti-clockwise to remove it7. If it is necessary, remove fluff and objects from thefilter recess.Make sure that the impeller of t

1210. Close the pump cover.When you drain the water with the emergency drain procedure, you must activate the drain system again:1. Put 2 litres of wa

4. Empty the drain pump. Refer to the emergencydrain procedure.5. When the drain pump is empty, install the inlethose again.WARNING! Make sure that th

POSSIBLE FAILURESProblem Possible solutionThe programme does notstart.• Make sure that the mains plug is connected to the mains socket.• Make sure tha

Problem Possible solutionThe appliance makes anunusual noise and vibrates.• Make sure the levelling of the appliance is correct. Refer to "Instal

4. Take out the laundry and then close theappliance door.TECHNICAL DATADimension Width/ Height/ Depth/ To-tal depth596 mm/ 819 mm/ 540 mm/ 553 mmElect

Energy consumption in kWh per year, based on 220 standard wash-ing cycles for cotton programmes at 60 °C and 40 °C at full andpartial load, and the co

Return the product to your local recycling facility orcontact your municipal office.37*

38

39

ELECTRICAL CONNECTIONWARNING! Risk of fire and electricshock.• The appliance must be earthed.• Always use a correctly installed shockproofsocket.• Mak

WWW.ZANUSSI.COM/SHOP157020580-B-242018

THE APPLIANCE IS EQUIPPED WITH ...x1 x2x1Ex2x1 x1x1 x2x4 x1 x1BA C DF G H LUNPACKINGWARNING! Use the gloves.WARNING! Remove all the packaging and the

124. Return the appliance in vertical position andremove the socket polystyrene protection.5. Remove the power supply cable and the drainhose from the

POSITIONING AND LEVELLINGx41. Install the appliance on a flat hard floor.WARNING! Make sure that carpets donot stop the air circulation below the ap-p

The inlet hose1. Remove the inlet hose from inside the drum.2. To connect the water inlet hose towards the prop-er direction and with the proper incli

Ø 40 mmTo a stand pipe with vent-holeDirectly into a drain pipe at a height of not less than60 cm (23.6”) and not more than 100 cm (39.3”).The end of